updating-bukobot-printer-firmware [Bukobot 3D Printer Instructions & Docs]

--- updating-bukobot-printer-firmware [2012/12/05 06:00]
buildrob
+++ updating-bukobot-printer-firmware [2012/12/06 14:52] (current)
buildrob
@@ Line 1: / Line 1: @@
-====== Updating your printer's firmware ======
+Moved to http://bukobot.com/software-to-install#printer-firmware
-Your Bukobot printer controller (an Azteeg X1 or X3 board) comes pre-installed with the correct Marlin printer firmware for your model. However if you later need to modify or update the printer firmware then follow these instructions:
-  - Download the Arduino IDE from http://arduino.cc/en/Main/Software and extract it into a directory.
-  - Go to [[marlin_configuration]] and download the correct Marlin printer firmware version for your printer. Extract it to your hard disk.
-  - Close your printer host program if open (such as Repetier-Host).
-  - Start the Arduino IDE (arduino.exe)
-  - Set the board type correctly in Tools->Board:
-    - For X3: Select Arduino AT Mega 2560 or Mega ADK
-    - For X1: Select Arduino Mega (ATmega1280)
-  - Set the serial port correctly in Tools->Serial Port.
-  - Open Marlin.ino from your Bukobot firmware directory (File->Open).
-  - Press Verify to compile the firmware (should get no errors)
-  - Connect your printer controller if not already connected.
-  - Press Upload to upload the firmware to the board.
-  - That's it.